Electric Motor Repair Electric Motor Maintenance-Martindale Products
phone:  216-521-8567
fax:       216-521-9476
Site Search:
CLICK HERE for Printable Version of this page.

Kut-Kwik Undercutter
Three Models - 3 saw Spindle Speeds

Click here to see Mini Kut-Kwik Undercutter not shown on this page 

      Kut-Kwik is a very small light-duty air-driven undercutter   designed for reaching into limited spaces where other undercutters cannot be used.  It is not meant for the heavier duty and more continuous service of our other portable undercutters.
     There are now 3 versions of the Kut-Kwik Undercutter available to accommodate the various needs of our customers.
Model KK32: 4,000 RPM version has gained increased popularity since it was introduced.  It is still the most popular and practical unit for use with high speed steel saws and V-Cutters.
Model KK50: 5,300 RPM version is recommended for use with tungsten carbide saws.  It should be noted that because of the brittle nature of carbide, these saws are more susceptible to breakage and should only be used by skilled operators.  The higher the price of carbide can normally be justified by the shorter time required to complete the job because of the higher operating speeds and less down-time required to replace cutters.
Model KK180: 20,000 RPM version is intended for use with diamond coated undercutting wheels.  Extremely fast undercutting is made possible by high speed tool which will more than justify the higher priced diamond wheels. Again, this tool is only recommended for use by more skilled operators.

Minimum compressed air requirement for
proper operation is 11 CFM @ 90 PSI.

Three Models - 3 saw Spindle Speeds:

Model RPM H.P. Length Wt. Catalog Number
KK32 4,000 .3 9-1/2" 1-1/2# KTKW032
KK50 5,300 .3 9-1/2" 1-1/2# KTKW050
KK180 20,000 .9 11-1/2" 2-1/2# KTKW180
Net Weight 2-1/2 lbs., Shipping Weight 4 lbs.

Diamond Coated
Undercutting Wheels
For use with Model KK180

O.D. I.D. Thicknesses Catalog Number
3/4" 5/16" .020, .030, .040" DIAW3(add thicknesses)
7/8" 5/16" .020, .025, .030, .035, .040, .045, .050, .055, .060, .065" DIAW7(add thicknesses)


For use with Model KK32 or KK50
High-Speed Steel O.D. I.D. Catalog Number
65-HS Saws 3/4" 5/16" HSMS65
75-HS Saws 7/8" 5/16" HSMS75
Tungsten-Carbide O.D. I.D. Catalog Number
65-TC Saws 3/4" 5/16" TUNS65
75-TC Saws 7/8" 5/16" TUNS75
For further specifications see H.S.S. or
Tungsten-Carbide Mica Saws.

Home | Metal Working Mica Saws | Rotary Burs | Undercutters | Abrasives | Commutator Grinders | Electrical Test Equipment | Electrician's Hand Tools | Other Products